Solutions

Can't use the new sensors

Modified on 2025-06-10 14:09:00 +0200

The new sensors for Exchange (using Powershell) and the SNMP Dell Sonicwall don't seem to be included in PRTG Network Monitor 13.3.5.2952 Setup Commercial (Stable), or atleast I'm unable to find or add them after updating to this version.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
new sensors are by default only visible for administrators in PRTG. For all other users/groups the sensors have first to be activated in Setup | User Groups in the according group. In section User Group Settings just set the ticks to the sensors you want to show for these user group under option Users May Create These Sensor Types.
Best regards

Sep, 2013 - Permalink

That was it. Thanks Konstantin.

Sep, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can't use the new sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.