I have a issue with the reports of PRTG. I am running just a simple ping report with no graphics. The issue is that all the data I need is in the top 1/3 of the page. The rest of the page is blank and because I am doing this on over 56 devices I now have 56 pages of where only the top 1/3 of the page has information. Is there a way to make PRTG condense the information so is there a way to get more than one device on a page?
Getting more entries on reports
Modified on 2025-06-10 14:09:30 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. I'm very much afraid this is not possible, but I will forward your feedback, to the suggestions on improving the reports.
best regards.
Aug, 2013 - Permalink