I downloaded PRTG trial version and like to configure cisco switch to monitor network traffic. It seems like i need to configure on switch side to add sensor but i'm not sure how to configure snmp on the switch. Can you please help?
SNMP configuration
Modified on 2025-06-10 14:09:34 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Seeing as this can vary somewhat depending on the precise device, we would suggest heading to www.cisco.com and consulting the configuration manual (generally available under the "Support" section) for the device in case.
Jan, 2013 - Permalink