I added a Error Limit Message to a channel. When the sensor goes down, the message appears in PRTG, but I can't find it in the email notification. Is it suppose to be in there?
Is Error Limit Message suppose to appear in email notifications?
Modified on 2025-06-10 14:10:24 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. The "Error Limit Message" should appear as the sensor message in the notification. Can you please upload a few screenshots showing the "Channel Settings" of this particular sensor, and the later on received email notification? Thank you!
best regards.
Aug, 2013 - Permalink