how to send last value of volume in volume trigger
Modified on 2025-06-10 14:10:49 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello,
We are going to use volume trigger in PRTG. When sensor's total volume crossed the given number we need to trigger the nitification. Here when are able to do trigger for volume. In that notification we are using HTTP web service to call and passing sensor id with place holder. Here we need the total volume at the time of volume tigger and pass it to the web service. Is there any place holder or some thing to pass total volume to the webserive ?
Thank you,
Nagarjuna
Article Comments
Hi,
a full list of all available placeholders can be found here. In your case you might try using %lastvalue.
Best regards
Aug, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
a full list of all available placeholders can be found here. In your case you might try using %lastvalue.
Best regards
Aug, 2013 - Permalink