Port Sensor for range of IP's
Modified on 2025-06-10 14:10:55 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Is there anything included where I can scan a range of IP addresses checking if a specific port is closed? I know I can setup individual sensors for each IP, but I have hundreds of addresses to check (many class C blocks). I was hoping to have one sensor per IP block (e.g. 192.168.0.0/24).
If this has to be a custom sensor can you please try to point me in the right direction?
Thank you -
Article Comments
Hello,
thank you very much for your KB-Post. I'm very much afraid this is not possible. Only individual sensors per device are possible. Sorry.
best regards.
Aug, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. I'm very much afraid this is not possible. Only individual sensors per device are possible. Sorry.
best regards.
Aug, 2013 - Permalink