I have two Junipers SSG-140 that are my firewalls. How can I configure the sensors to monitor the interfaces 5 and 6 of a Juniper?
How to creat a sensor for monitor Juniper interfaces
Modified on 2025-06-10 14:10:57 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Just to check, the SNMP Traffic Sensor does not display these interfaces 5 & 6?
best regards.
Aug, 2013 - Permalink