I have the syslog sensor set up on my probe device. But I am not getting any information on it. (Right now Im getting 0 for all data) I have 4 devices that I want information to show on the syslog. How can I add them to the syslog?
SYSLOG Sensor Question
Modified on 2025-06-10 14:11:26 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. I'm afraid the only Option would be to add 4 Syslog Sensors, and have each one filtering for a specific sender IP. Please also see: How can I use PRTG’s syslog sensor and what are its limitations?
best regards.
Aug, 2013 - Permalink