Solutions

ip probe connection

Modified on 2025-06-10 14:11:38 +0200

Hi All

Is it possible to change in Setup > Probes

The IPs for probe Connections

My PRTG server has two network card on two separate network and I want to monitor devices on both network.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. You can change the IPs on which Probe Connections are accepted in the PRTG Server Admin Tool, on the Core Server-Tab.

best regards.

Aug, 2013 - Permalink

Thank you Torsten

Tha'ts exactly the solution

Aug, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

ip probe connection

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.