Where do I enable "Log Stream Data to Disk"?

Modified on 2025-06-10 14:11:48 +0200

I would like to review raw logs for an sflow sensor, so I can find the interface index. I can't find where to enable the raw logging. Thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
due to some special behaviour of the sFlow sensor the option Log Stream Data to Disk (for Debugging) is not available in the sFlow sensor. Sorry.
Best regards

Aug, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Where do I enable "Log Stream Data to Disk"?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.