WMI Vitality not available
Modified on 2025-06-10 14:13:15 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
How can I use the Vitality Sensors? I do not find them in the WMI Sensors list nor by searching for vitality.
Article Comments
Did try this already:
Passende Sensortypen - Search: vital - Ergebnisse: 0
Jul, 2013 - Permalink
What version of PRTG are you using?
Jul, 2013 - Permalink
PRTG Network Monitor 13.2.3.2285 x64
Jul, 2013 - Permalink
May you send a screenshot, showing the sensor add process to support@paessler.com.
When sending the screenshot please refer to this case.
Thank you!
Jul, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
please use the WMI Vital System Data Sensor. Just search for vital when trying to add the sensor. It should be the only one showing up then.
Best regards
Jul, 2013 - Permalink