Hi. I have multiple vlans on an interface on a cisco ASR 901 router. Is there any way to monitor each vlan on the single interface with prtg?
How can i monitor separate vlans on a same interface?
Modified on 2025-06-10 14:13:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. May I ask you to please use our SNMP Tester, preferably the new betaversion of the Tester 5, to perform a "Scan available standard interfaces" against the target device? Which results do you get in the Tester? Please send us the result logfile from the Tester.
best regards.
Jul, 2013 - Permalink