SNMP custom sensor display value per minute

Modified on 2025-06-10 14:14:46 +0200

I 've created custom SNMP delta sensor which monitors number of error packets on interface in 60s intervals. The sensor displays results in #/s. The problem is, that number of erroneus packet on monitored interface is small number (0 -2 /min).

Is there a way how to display results in #/minute? In other words. Is it possible to display delta value (volume) and not the speed?

Petr

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post! I'm very much afraid the volumes are not graphed. But they are "shown" / listed in the data tables, underneath the graphs. The sensor itself can't be set to use "/minute" as unit. Sorry.

best regards.

Jun, 2013 - Permalink

OK. Thanks for the reply, Torsten.

Petr

Jul, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP custom sensor display value per minute

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.