SNMP Traps handling
Modified on 2025-06-10 14:15:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hello everyone,
I'm maybe not the first asking the question but how can I monitor snmp traps from devices where I'm not able to install remote probes? Like sensorprobes (akcp), hp lto autoloader, fringerprint terminals... stuff like that.
Thanks.
Best regards,
jan
Article Comments
Hello,
thank you very much for your KB-Post. Just configure those devices to send their SNMP Traps to your PRTG Host, where you can then monitor them with a SNMP Trap Receiver sensor.
best regards.
Jun, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Just configure those devices to send their SNMP Traps to your PRTG Host, where you can then monitor them with a SNMP Trap Receiver sensor.
best regards.
Jun, 2013 - Permalink