Hello,
I'm deploying a new PRTG installation wich will be on a vitual machine.
I will have 1000 sensors that 600 are cisco Netflow.
My probe interval is 30 seconds.
What is the Hardware Required for that implementation ? how much of the memory RAM ?
thanks.
Article Comments
Whether you could actually monitor 600 NetFlow sensors depends on the amoount of flows received. Would this entail one NetFlow stream that would split the data into 600 entries by filters or would you actually want to monitor 600 routes, each with one stream? In the latter case you would need to test if this would be able to achieve, seeing as flow sensors do use up a large amount of resources. Accordingly, it would require a very powerful machine.
If the 600 sensors were to be too much for a single node, you would have to distribute the load over multiple remote probes. However, the only way to be certain if this is possible would be to try directly on the actual system / network.
What would not be possible, however, is to monitor this type of environment via virtual machines. In such scenarios it is almost imperative that physicaly servers are used.
Jun, 2013 - Permalink
Whether you could actually monitor 600 NetFlow sensors depends on the amoount of flows received. Would this entail one NetFlow stream that would split the data into 600 entries by filters or would you actually want to monitor 600 routes, each with one stream? In the latter case you would need to test if this would be able to achieve, seeing as flow sensors do use up a large amount of resources. Accordingly, it would require a very powerful machine.
If the 600 sensors were to be too much for a single node, you would have to distribute the load over multiple remote probes. However, the only way to be certain if this is possible would be to try directly on the actual system / network.
What would not be possible, however, is to monitor this type of environment via virtual machines. In such scenarios it is almost imperative that physicaly servers are used.
Jun, 2013 - Permalink