How to auto set a alert to Warning status?

Modified on 2025-06-10 14:15:55 +0200

Is it possible to auto set a sensor to "Warning" state as soon as it's alerts rather than auto acknowledging it? Also, an email will be sent to appropriate teams to act on, as soon as the sensor turns yellow?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

I'm afraid setting a sensor to a Warning state rather than acknowledging the same is not possible. Notifications can, however, be sent as soon as the sensor state changes (this would include changes from Down to Warning or Down to Up, etc.).

Jun, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to auto set a alert to Warning status?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.