Solutions

Automated process for changed software

Modified on 2025-06-10 14:16:04 +0200

Do you have a best practice solution to let PRTG now there was a software update on a monitored system and some services were new? It's not a problem if a service is missing after an update because the sensor will went to error state, but if there were some new services we must figure out which services this could be...

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. I'm very much afraid PRTG does not monitor for available updates on target machines. But if services do not start after updates, the sensors (monitoring these services) will be in error state.

best regards.

Jun, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Automated process for changed software

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.