We want to have a report where we can see all sensors with errors for a period of time. We can specify this in the protocol section of PRTG, but we want to schedule and email this report. Is this possible and if yes, how?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post. thank you very much for your support ticket. I am very sorry but it is not possible to set such "conditions" for a report, to only have sensors that were in error-state in a certain period. But maybe the solution of the following KB-Post may serve as a work around: How can I create a report about the notifications, alarms and downtime of a sensor?

best regards.


Jun, 2013 - Permalink