But when I go to the device, add sensor, and select the library, the box comes up, showing 'working..' go any further, and sensors not added to device
SMNP library not add
Modified on 2025-06-10 14:16:35 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Please provide a few more details. What SNMP Library are you using? May I ask you to please use our SNMP Tester, preferably the betaversion of the new Tester 5, to perform a scan with the same SNMP Library against the target device? Which results do you get in the Tester? Please send us the result logfile from the Tester.
best regards.
Jun, 2013 - Permalink