Periodically we have a higher than normal amount traffic accross a particular interface. How can we use PRTG to find out where this traffic is originating from? Could Similar Sensors Analysis help us with this?
Where is the trafic coming from
Modified on 2025-06-10 14:17:41 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
yes, the similar sensor analysis could be one approach to find the device causing the bandwidth peaks. As an alternative you might also have a look at this article which describes also how to identify such devices.
Best regards
Jun, 2013 - Permalink