How to create one (SNMP Custom) sensor with two OID values? (without using Sensor Factory)
How to create one sensor with two OID values?
Modified on 2025-06-10 14:18:24 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
This is not possible. SNMP Custom sensors use one OID per sensor. Only SNMP Traffic sensors allow for two channels (in / out) and the combined values. This is not possible with other SNMP sensors. Sorry.
Jun, 2013 - Permalink