How to get HTTPS access to server back working after new license?

Modified on 2025-06-10 14:18:49 +0200

I have been using PRTG for two years, with local and remote HTTPS access to the network monitor.. I purchased a new one-year license yesterday. When I installed the new license, the Server Administrator was unable to configure SSL on port 443 - although it has been working without problems for two years.

I was able to configure access using HTTP port 8080, but I want to go back to HTTPS. How can I do that?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
do you get an error message when trying to set up port 443? If so what precise error message?

May, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to get HTTPS access to server back working after new license?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.