Solutions

webinterace connection timeout

Modified on 2025-06-10 14:19:37 +0200

I have recently installed PRTG software over VM . And config 13000 sensors. But I usually cannot connection webinterface . I check windows system ,CPU and RAM utilization is very high.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Since this is a specific issue that we are dealing with at the moment, can you please send in your System Logs to us at support@paessler.com and reference this KB article?

May, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

webinterace connection timeout

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.