Hi, In PRTG6 it's possible to create a sensor in "add sensor" with type "sensor Aggregation". With and Aggregation Sensor you can add up the data of two or more sensors and create a new sensor with the aggregated readings. How i can do this in PRTG9?. For exemple to monitor traffic for a set of ports in a switch. Thanks a lot.
Sensor Aggregation
Modified on 2025-06-10 14:20:01 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
for this purpose in PRTG 9 you might want to have a look at the Sensor Factory Sensor. It has the same functionality than the sensor aggregation in PRTG 6.
Best regards
May, 2013 - Permalink