Solutions

SNMP Dell PowerEdge

Modified on 2025-06-10 14:20:41 +0200

I was responsible for monitoring the operation of general (fans, hard disk, etc.) of the equipment Dell PowerEdge by ZABBIX tool.

However, I can not create any reliable procedure and observed in previous questions that you could provide tips for SNMP OIDS that could solve some problems.

I thank you

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

If you are trying to create a Poweredge Sensor for your server, you would need to install the Open Manage software which will provide the SNMP information that PRTG needs to monitor the device. Poweredge Health Sensor

Once that software is installed on the server, you should be able to create that sensor on the PE server and monitor those hardware statistics.

May, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP Dell PowerEdge

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.