Cisco CPU Temp Sensor
Modified on 2025-06-10 14:20:50 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
I'm trying to monitor the CPU temperature of a pair of Cisco 3925's in our network and I think I've found the correct OID using MIB Importer but when I put it into PRTG it comes back with the following error: No such object (SNMP error # 222). The MIB etc details are as follows:
Agent: CISCO-ENVMON-MIB
Group: cisco env mon temperature status: #[1.3.6.1.4.1.9.9.13.1.3.1.1]
Name: cisco env mon temperature status value
OID: 1.3.6.1.4.1.9.9.13.1.3.1.3
Article Comments
Have you tried to read this OID with our SNMP tester to see what value it returns? If this is readable by the SNMP tester, then it's possible that the device may be setup incorrectly.
May, 2013 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Have you tried to read this OID with our SNMP tester to see what value it returns? If this is readable by the SNMP tester, then it's possible that the device may be setup incorrectly.
May, 2013 - Permalink