i have been trying to set up bandwidth/traffic snmp sensor for my asa but i end up getting a error "Unknown data type (= ) (SNMP error # -1001)". I am new to prtg can someone plz help me resolve this issue. I have enable snmp on host and on asa aswell, but still no use.
"Unknown data type (= ) (SNMP error # -1001)"
Modified on 2025-06-10 14:21:21 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
Could you tell me which version you are using? Also, can you run an interface scan with our SNMP tester and post it here?
May, 2013 - Permalink