Can I send a trap when a sensor gets down?

Modified on 2025-06-10 14:21:46 +0200

I need to send a trap to a Trap Management console I have in the installation, because all troubles must be handled by SNMP. So it´s important to me that when a sensor changes state (warning, down, etc.) the notification could be a trap sent to an IP address, where I have my trap management console.

Could be possible?

Thank you!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

in the web interface, go to

Setup -> Account Settings -> Notification and edit an existing notification or create a new one and enable

Send SNMP Trap

and enter your settings.

Then you can use that notification for your sensors.

May, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can I send a trap when a sensor gets down?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.