Solutions

Sensor Factory threshold trigger

Modified on 2025-06-10 14:22:08 +0200

I have sensor factory in my PRTG, it's collective sensor of how many connections going to my Proxy device, separated by Virtual IP. So I have set threshold trigger between certain number of connection, but i kinda hope will get Web/Sound Alarm or notif in Alarm Page, not only email notif. Can PRTG do that?

System Status PRTG Version PRTG Network Monitor 12.4.6.3342 x64

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

For a sensor factory sensor, what you could do would be to create upper and lower limits that would put the sensor into an Error State or warning state. You can also edit the associated message that comes with the Error and Warning limits. Channel Settings

May, 2013 - Permalink

Thanks Greg! I just created the Limit as you said.

May, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sensor Factory threshold trigger

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.