The incoming data from WMI Logical Disk Sensor is quite low and do not exceed 0,03 value. So good idea is to use scale on this sensor, but i can't find such option in Settings tab, where according to manual it must be. PRTG Network Monitor 13.1.2.1383
Where is "Scale" option in WMI Logical Disk Sensor?
Modified on 2025-06-10 14:22:51 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Unfortunately, scaling is not available for this sensor. This is for internal technical reasons.
As a workaround we recommend you use a Sensor Factory sensor to "replicate" your sensor. Scaling is available for sensor factory sensors.
Apr, 2013 - Permalink