After restarting PRTG Server - I've noticed that "Bandwidth Traffic IN and Bandwidth Traffic Out" of some PC's has changed to high amount of "Bandwidth".

Before it was normally has the Bandwidth Traffic IN and OUT of 300 kbits/second but now it became to 1,500 kbytes/seconds or morethan.

What should I do to get it back to normal Bandwidth Traffic..? Hope my question and how I describe it was clear enough.

Thank you.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

It could be that this sensor had a spike in data and that has set the maximum value higher for these sensors. You could delete these sensors or clone them to create a new sensor without these spikes then set those channels to ignore spikes.

Filter Spikes From Graphs in PRTG


Apr, 2013 - Permalink