Solutions

senors usage

Modified on 2025-06-10 14:23:22 +0200

I am still running the trail version, but will be hoping my company invest in this product. If they limit me to 100 sensors and I use them all. I add a new device to my network and require to monitor it for a short period can I disable active sensors to allow me to have sensors avaliable to monitor my new device. If yes when I go back to my orginal device will all the data still be there from the previous logs

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
yes, this would be the way to go. You will have to just pause some of the active sensors and then un-pause the ones you want to monitor. When pausing a sensor all its data recorded before it was paused is still accessible but the sensor will not monitor anything when it is paused.
Best regards

Apr, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

senors usage

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.