Solutions

Delete a channel

Modified on 2025-06-10 14:24:08 +0200

Hi there I want to remove the downtime channel on mass on all my sensors. I have gone through and removed all of them manually. but for future ref is there a way to do this by bulk.

also when I add a new sensor how do I stop it adding in future

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,
you can bulk edit the downtime channel using Multi Edit in PRTG. And no, I'm afraid you cannot disable the downtime channel in general.
Best regards

Apr, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Delete a channel

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.