SNMP is not working // unable to retrive data

Modified on 2025-06-10 14:24:16 +0200

Hi ,

I am getting allot of SNMP based on One of my Subnets ,it is unable to receive any Data,what could be the problem ??

Error opening snmp session: Unknown host (xx.xx.x.x:161) (SNMP error # -2006)

It was able to receive the data while the Subnet was in Auto discovery Mode!!!

Regards Thiru

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

From the error message it would seem the sensor is not able to connect to the IP address in case. In order to provide proper troubleshooting, please forward us an email to support@paessler.com, with reference to this knowledge base thread. Please include a screenshot of the settings of one of the affected sensors.

Apr, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP is not working // unable to retrive data

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.