Solutions

Fault,Warning sensor report

Modified on 2025-06-10 14:24:26 +0200

Hi,

Is it possible to make a Report of which sensors where fault and in a warning state. We want to make a report which shows us the down sensors en warning sensors over a period of time.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB Post. This is possible, with a added trigger and notification, to the sensors you want this report of. Please see the following KB-Article and its best answer: How can I create a report about the notifications, alarms and downtime of a sensor?.

best regards.

Apr, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Fault,Warning sensor report

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.