I just setup a cluster and I would like to keep the sensors from turning red if one node is unable to reach the device. Is this possible?
When using a cluster, can I keep the sensor from going red when it's partial down?
Modified on 2025-06-10 14:25:25 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
no, this is not possible due to the cluster architecture. Sorry. Best regards
Apr, 2013 - Permalink