Hi, we are starting to test PRTG within our organisation but we have noticed that every report we run does not show source or destination IP's. Can someone please advise?
thanks
Natasha
PRTG Report not showing source and destination
Modified on 2025-06-10 14:27:19 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I presume you are referring to reports on Flow/Sniffing Sensors and their Toptlist data. If so, then I'm very sorry but the Toplists cannot be reported. So it's not intended to have periods of 24 hours or longer on Toplists actually. But if you have Netflow Sensors filtering for certain IPs/Hosts then the normal sensor results can be reported and would also show bandwidth-amounts for certain IPs/hosts.
best regards.
Mar, 2013 - Permalink