When I try to add a Xen sensor, I get an error

Modified on 2025-06-10 14:27:45 +0200

The error message states "The request was aborted: Could not create SSL/TLS secure channel"

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

This means, that you did enter wrong credentials in the device settings. Please go to the device settings and enter correct credentials in the category "Credentials for VMware/XenServer".

Mar, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

When I try to add a Xen sensor, I get an error

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.