Is there a way to show uptime and not the loading time for specific HTTP sensors on the Maps designer?
How do I display HTTP uptime on Maps
Modified on 2025-06-10 14:27:55 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm very much afraid this is not possible. The Uptime/Downtime Values in the "General statistics" of sensor are calculated for display each time a page is viewed, but are not available in maps.
best regards.
Mar, 2013 - Permalink