I have a master and one failover node. It doesn't matter which server I connect to I see a probe for the master but not for the failover node. I attempted to add the probe from the failover as a remote probe to the master. I then set it back to being a local probe to the failover but it still shows up as a probe that is disconnected and cannot figure out how to delete it.

I need to get this configured and working properly to demo for our partners.

I also have a problem with one server's sensors the failover node shows all sensors down except for ping and the master shows all sensors up, how can this be.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

as said, the probe of a failover-node needs to run as Local Probe. Only then the node can collect data and do its monitoring.

Best Regards.


Feb, 2011 - Permalink

I think the question had to do with the visibility of Probe nodes on the failover node, I am having the same issue

we are running 8 probes, I can see them on the master node but I cannot see my probes in the failover node


Mar, 2013 - Permalink

Remote probes can only be seen from the Master node and not from failover nodes, a remote probe can be connected only to one Server and deliver monitoring data there. Best Regards


Mar, 2013 - Permalink