Solutions

Sensors returning OK

Modified on 2025-06-10 14:28:09 +0200

Since updating to 13.1.2 a lot of our custom SNMP sensors are just returning a value of OK instead of the correct response. We can fix this by going into the settings changing the OID value to something then changing it back and everything then works fine. Why is this happening? We have about 6000 sensors and do not want to have to do this for everything single one.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Please forward an email to support@paessler.com refering to this thread. Please provide screenshots of the issue, as well as of the sensor settings, including screenshots of the informaton available under the "Channels" tab, so that we have a reference as to the configuration of the sensor in case.

Mar, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sensors returning OK

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.