Solutions

Report table rows

Modified on 2025-06-10 14:28:18 +0200

I've been asked to generate a report for a specific time frame of between 18:00-21:00. I've got this setup accordingly with the "Report only for specific hours-of-day" however it is still generating redundent rows outside of that time frame but with all the values set to 0%.

Is there any way to stop the generation of these essentially blank rows? 1000+ rows of:

Is a bit ridiculous for a meaningful report, especially with multiple sensors.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Ithank you very much for your feedback. We really appreciate it!
Unfortunately, this cannot be changed, but we do have a general overhaul on the reporting on the agenda for PRTG, I just can't give a precise schedule. Please bear with us.

best regards.

Mar, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Report table rows

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.