Solutions

Report on Warnings

Modified on 2025-06-10 14:28:26 +0200

I was wondering is it is possible to get a report on sensors in a warning state. Basically what I am looking for is similar to the Uptime/Downtime report except I would rather it be Uptime/Warningtime.

I'm not seeing many options on this from the GUI but I have heard that it may be possible through Powershell scripting.

The reasoning for this is that we monitor our MPLS circuits for remote offices by putting the sensors in a downstate if it is down and putting the sensor in a warning state if the bandwidth is saturated. This type of report would be valuable for us to see what circuits are candidates for an upgrade.

Thank you.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm very much afraid warning states are not transported to reports. So only way I can see is getting the data via the PRTG API, and then calculating this externally.

best regards

Feb, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Report on Warnings

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.