How can I monitor Cisco UCCX and CCM services?

Modified on 2025-06-10 14:28:34 +0200

I already have the basic sensors to monitor for Ping but is there a way to monitor the services that are required to run, and if the service stops to alert us?

I saw someone use the SNMP with Nagios and monitored differnt MIB's. Is there a way to monitor the different MIB's and find out what the MIB's are in PRTG?

Any input is appreciated, Peter P

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

if you have the MIBs you can import them with our MIB-Importer, and then use them as SNMP Library Sensors.

best regards.

Feb, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I monitor Cisco UCCX and CCM services?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.