So in the schedule setup i see where i can dictate what time sensors are reported, but i cannot seem to fine tune WHEN the reports are run. If i want a report that runs only on monday-fridays without weekends i have to do it manually. is there anything coming up in the new version that will allow more fine tuning there? or is there something i'm missing?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

thank you very much for your KB-Post! I'm sorry it's not quite clear. Is this about when a report is generated (so each day you have a report about the previous day in your mail inbox for example)? Or about the data in the report itself?

best regards.


Feb, 2013 - Permalink

It's about When the report is generated. I get a report every day at 5pm, I want to get that report only monday-friday. there does not appear to be a way to change that in the reporting.


Feb, 2013 - Permalink

I'm afraid that cannot be set in the moment, but I'll add it to the wishlist!


Feb, 2013 - Permalink