Channels Table on Sensor Overview Page Truncates

Modified on 2025-06-10 14:29:04 +0200

When reviewing one of our custom DFS Replication status sensors, we noticed the Channels table at the bottom of the Overview tab on the sensor's page was not showing all channels we were returning from our script. Is this a known limit or a bug? I haven't found any information on this in the help pages.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

can you please upload a screenshot showing this? Or send us an email with the screenshot to support@paessler.com?

best regards.

Feb, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Channels Table on Sensor Overview Page Truncates

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.