No Sensors available for Exchange 2007 via WMI?

Modified on 2025-06-10 14:29:07 +0200

Hi,

i just tried to add some Exchangesensors via WMI. I first created the new computer, selected email, selected WMI Exchange and proceeded. In the next dialog there were no performance counters to select.

What is wrong? I just updated to new newest version of PRTG. I can use WMI to get information about diskusage.

Best regards Hannes

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid if there are no possible WMI Exchange sensors listed, it most likely is an issue in the WMI System on the target Exchange, and then it needs repairing. Please try to repair the WMI System on the target Exchange host.

best regards.

Feb, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

No Sensors available for Exchange 2007 via WMI?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.