Not sure if it is the latest stable version or not but I am no longer able to use Auto Discovery to get all devices discovered. It was able to discover network devices like switches however it missed the Windows hosts entirely. I am able to ping and remotely manage these machines from the probe. Also when I manually add the Windows target by IP address it finds it and discovers all its sensors.
Thanks, Andreas
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
Can you please go into PRTGs datafolder, there into the "Logs (System)"-folder and remove the "Auto Discovery Log.log". Then please create the same Auto-Discovery Group again, directly under the probe (not in any sub-group) with the same settings, and run the Auto-Discovery again, and send us the full content of the "Logs (System)"-folder as a zip-file via email to support@paessler.com or use the FTP-Upload Send Logs To Paessler...-Button on the Logs-Tab of the PRTG Probe Admin-Tool.
Also please send us the IPs (at least one) of the hosts which were not found by the Auto-Discovery.
best regards.
Jan, 2013 - Permalink