How can i know the highest traffic value on cisco interface through prtg sensor?

Modified on 2025-06-10 14:32:10 +0200

I just want to set the speed trigger when channel is above xxxkbit/second and to perform notifacation. But how can i know the highest traffic value through sensor. PRTG is monitoring Cisco 4500 series and 3700 series. I have added sensor and it can shows interface traffic.

Thank you you all ^^

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

have you considered reports? However, please be aware that the maximum values will be averaged in reports.

best regards.

Jan, 2013 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can i know the highest traffic value on cisco interface through prtg sensor?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.