For the duplicateobject API call, what is the targetid parameter? I have a sensor I'm trying to duplicate, but don't know what value I should be supplying for targetid. Making one up does not seem to work. Thanks.
What is the targetid parameter for the duplicateobject API call?
Modified on 2025-06-10 14:32:20 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi,
the targetid parameter refers to the id of the group the duplicated object should be attached to. When duplicating a sensor the targetid refers to the device the sensor should be part of.
Best regards
Jan, 2013 - Permalink